|
|
|
 this is ridiculous, a complete waste of time, and probably not particularly effective. I love it! - The other Gabe [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| this is ridiculous, a complete waste of time, and probably not particularly effective. I love it! - The other Gabe [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
12-04-2006, 14:30
|
|||||
|
|||||
|
Re: ULTIMATE CHALLENGE
So this took me about 20-30 minutes to assemble, and for the last 40 minutes I've been diddling around with surfaces and Inventor Studio. Thanks Petek! If you've got inventor, it's really easy to do, just 2 parts and 1 assembly was all it took.
list of parts: 20 hex shape, .625" flats all around 12 Pentagon shape, .625" flats all around When you go to constrain your parts, make sure you constrain (create in your mind a relative top and bottom to each part) to the bottom edge of each peice. that way when it bends into a icosahedron it will all fit. Good luck! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Chester Challenge 2006 | Wayne C. | General Forum | 24 | 29-10-2006 23:15 |
| 2005 Vex Challenge | FIRSTgurl93 | FIRST Tech Challenge | 0 | 11-11-2005 13:16 |
| Lansdale Catholic Robotics (272) announces VEX Challenge | pafwl | General Forum | 1 | 13-08-2005 16:18 |
| Challenge to West Coast Teams for 05 Regionals | D.J. Fluck | Regional Competitions | 29 | 16-08-2004 17:30 |
| favorite challenge | archiver | 2000 | 1 | 23-06-2002 23:20 |
Threaded Mode