Victor-PWM Cable connections

Josh Hambright · #1 15-04-2006, 13:20

An old fix that i can remember using on the old victor with the old style of PWM connector was to put a small dab of hot glue on the connector, this can also be done on the other end where they all connect to the RC. Using hot glue makes them stay in place but you can peel it off if you need to remove the connections.

RKElectricalman · #2 21-02-2007, 14:17

Quote:

Originally Posted by Josh Hambright

An old fix that i can remember using on the old victor with the old style of PWM connector was to put a small dab of hot glue on the connector, this can also be done on the other end where they all connect to the RC. Using hot glue makes them stay in place but you can peel it off if you need to remove the connections.

That or silicone.. that's what we use.. it's great

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ribbon Cable	emusteve	Electrical	6	13-01-2006 16:33
2 questions about LAN (10/100) cable.	Elgin Clock	IT / Communications	19	16-11-2004 12:04
Breaking Cable	WebWader125	Technical Discussion	13	28-05-2004 16:44
Fun Times at the Hardware Store	sanddrag	General Forum	10	19-03-2004 23:55
LEGO IR tower cable	Jeff Rodriguez	Chit-Chat	1	31-10-2003 16:23