Omniwheels - how?

[Daniel Morse]

213 used 45 degree omni wheel setup on our base to obtain a holonomic drive. Take a look at the photo attached to see the base. This allows us a full range of motion including rotation, linear motion (side to side), and a combination of the two in competition, which was extremely useful. The downside to holonomic base is the velocity that you lose to the rollers while moving in a motion such as forward, backward, or side to side due to the principles of how it works. Also, as was stated above, it is very easy to push the robot. For our team to approach this problem, we attached Kornylak omni wheels to a custom drive shaft and attached that to the KOP gearbox. The system is remarkably simple, and works very well. I would suggest that you begin exploring omni wheels on a simple premise like this, so that you develop an understanding of how they work. I also suggest looking at Kornylak to provide omni wheels, we used them in our robot and they performed decently well (except they shattered a few rollers if you tried to go up the ramp with them). Its a heck of a lot easier than making your own.