|
|
|
 Two students with no clue but enough dedication to work on something is always better than one expert who doesn't care enough not to leaveit until the last day. - Matt Krass [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
25-04-2006, 16:01
|
||||
|
||||
|
Re: [YMTC]: Inspect Redabot's Pneumatics
one possible thing i can see right now is rule R97
<R97> The Nason Co. pressure switch must be attached to the compressor output or Clippard tank(s) and be wired to the digital I/O port on the RC. The pressure switch CANNOT be used to directly power the compressor. another is that the rules specify a 20A circuit breaker for the off-robot compressor, while this specifies that redabot is using a 20A fuse. whether or not that is a distinguishable difference there, i have no idea. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| YMTC: Bluateam Refurbishes Bluabot's Mangled Arm | Natchez | You Make The Call | 23 | 15-04-2005 13:57 |
| YMTC: Should YMTC have a future | Natchez | You Make The Call | 13 | 21-04-2004 00:46 |
| YMTC: Bluabot and Redabot hanging? | Natchez | You Make The Call | 15 | 23-03-2004 01:42 |
Threaded Mode