Bending 2" diameter pipe/tubing

We are just helping to keep Home Depot from going Bankrupt :D . - E. Wood [more]

		Chief Delphi > Technical > Technical Discussion
Bending 2" diameter pipe/tubing

Thread Tools

Rate Thread

Display Modes

#12

03-05-2006, 23:33

ChuckDickerson ChuckDickerson is offline

Mentor / Bayou & CMP Division LRI

FRC #0456 (Siege Robotics)

Team Role: Mentor

Join Date: May 2004

Rookie Year: 2004

Location: Vicksburg, MS

Posts: 877

ChuckDickerson has a reputation beyond repute

Re: Bending 2" diameter pipe/tubing

I would be tempted to stop by a muffler shop or two and ask. I bet they could bend it for you for not much $. Ask if they have a scrap bin you could dig through and see if there is some mis-bends in there you could snag and cut as needed.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OCCRA]: diameter of the pipes	iheartpi	OCCRA Q&A	1	28-09-2005 20:26
Drive-train shaft size	Andrew Schuetze	Technical Discussion	27	27-07-2005 15:41

All times are GMT -5. The time now is 04:19.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.