|
|
|
 I think I just found a way to replace our entire robot drive team! (no big deal, they are graduating anyway!) :D - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I think I just found a way to replace our entire robot drive team! (no big deal, they are graduating anyway!) :D - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Easy OmniTrack
Well I was board so I made an OmniTrack in Alibre Designs. It uses square aluminum tubing as the frame. Then i drilled some wholes in it and welded a few connector pieces on it, put in the shaft, bushings, and roller and here it is. The roller isn't perfect, I know, so try to focus on the shape of it.
I'm an extreme "I want to make something" state. Last edited by Joe_Widen : 13-05-2006 at 15:15. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Omnitrack Summer Project? | Gabe | Technical Discussion | 27 | 07-09-2006 00:28 |
| Easy C Tutorials | jbbjjbt | Programming | 3 | 21-02-2006 08:40 |
| Easy C | redragon226 | Programming | 8 | 28-01-2006 16:56 |
| MPLab to Easy C | sbwprotoss9 | Programming | 1 | 12-01-2006 22:00 |
| easy game? | JulieB | General Forum | 0 | 12-01-2005 09:29 |
Threaded Mode