|
|
|
 What Delphi says doesn't matter. What the official Q&A says matters. - Tetraman [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| What Delphi says doesn't matter. What the official Q&A says matters. - Tetraman [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
13-07-2006, 02:05
|
|||||
|
|||||
|
Re: Bandsaw Troubles
You could also perform a test by using different thicknesses of plastic, wood, and aluminum, noticing when the blade feels like it is running wrong. As sanddrag suggested, try adjusting the tension of the blade tighter. You could also be feeding too fast, which would cause the blade to twist off your marked line very easily.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera Troubles | cmurdoch | Programming | 9 | 11-02-2006 11:34 |
| IR Beam Troubles | Goldeye | Programming | 2 | 21-01-2006 17:15 |
| Tilt Troubles | Mumford 406 | Programming | 4 | 29-03-2005 22:19 |
| Gyro Troubles | SteveO | Programming | 13 | 30-01-2005 16:46 |
| MMH Troubles | Justin Stiltner | Kit & Additional Hardware | 3 | 28-01-2004 16:03 |
Hybrid Mode
