Axel Diameters

[Booger]

thanks homie

[AndyB]

We use 3/8"

[M4 Sherman]

If you use Grade 8 bolts, 3/8" works fine.

[Billfred]

1293's used 3/8" threaded rod for two seasons with no complaints at all. (After some personal experience with my omnidrive project, however, I'd be inclined to make the switch to bolts.)

[Alex Cormier]

I prefer 1/2" shaft, it is smaller and saves that precious weight.

[Billfred]

Originally Posted by Alex Cormier

I prefer 1/2" shaft, it is smaller and saves that precious weight.

Isn't 3/8 less than 1/2?

[Alex Cormier]

Originally Posted by Billfred

Isn't 3/8 less than 1/2?

minor details.

[AndyB]

Originally Posted by Billfred

Isn't 3/8 less than 1/2?

Only in metric...

[Booger]

Originally Posted by Billfred

Isn't 3/8 less than 1/2?

hahhaha thats what i was thinking

[Raul]

If you use 3/8, make sure it is steel.
If you go to 1/2, you can use aluminum - this is our typical shaft size and material.

[ConKbot of Doom]

3/8" shaft must be supported on both sides, you can probably do without the extra support with 1/2". In 2005 we used 3/8" shaft with the skyway wheels, and slowly the axles bent upwards. They would be fine if it was just our robot driving around on the flat surface, but it had to content with other robots weight some of the times, and being leaned back onto 2 wheels for getting it up onto the cart, etc... Luckily, we just had to undo some bolts, take off some shaft-locks, and slide out the old axles, put new ones in, put wheel and shaft locks on, tension up the chain, and tighten the bolts back up.

[Gdeaver]

I highly recommend using 3/8" grade 8 bolts with the KOP frame and Skyway wheels.

[Booger]

we used the high traction robot wheels and they work very good with our design. the only thing im having trouble wiht is trying to figure out how much bigger the hole needs to be where the shaft goes into the side plates

[Madison]

Originally Posted by Booger

we used the high traction robot wheels and they work very good with our design. the only thing im having trouble wiht is trying to figure out how much bigger the hole needs to be where the shaft goes into the side plates

If it's a powered axle in bearings, you'll need to bore press fit holes large enough for the bearing outer diameter. If you're using a dead axle and you're not intent on being too precise (which seems to be the case), you ought to be fine by drilling out the hole with a drill bit the same diameter as your axle and then opening it up slowly by hand using a deburring tool or the like.

[Triple B]

233 uses 1/4" diameter axles