axel hole width - Chief Delphi

Great things don't just happen to HoF teams; HoF teams make great things happen. - Siri [more]

		Chief Delphi > Technical > Technical Discussion
axel hole width

Thread Tools

Rate Thread

Display Modes

17-07-2006, 11:07

Booger

Registered User

FRC #0637

Join Date: Jul 2006

Location: Montville, NJ

Posts: 74

axel hole width

im making plans for a sideplate, and i have a 3/8" shaft that is going to go into a slot that lets it move left and right. after reviewing my plans i noticed that the hole was only 3/8" wide. how much wider are you suposed to make it so it fits and everything?

__________________
Collars up!

637

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Axel Diameters	Booger	Technical Discussion	18	25-07-2006 19:20
Measuring a Pulse Width	MikeDubreuil	Programming	22	21-07-2005 10:22
Width of the Ball Holders	stuy694	Rules/Strategy	2	10-01-2004 18:11
Width of the Ball Release	Jeff Waegelin	General Forum	1	10-01-2004 17:02
Bridge Width Question	archiver	2001	3	23-06-2002 22:54

All times are GMT -5. The time now is 04:24.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.