|
|
|
 I have a bobble head? - Koko Ed [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I have a bobble head? - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Timing Belt Clamp
Could you just overlap the two open ends of the belt, and then pop rivet it together? The teeth in the belt will take most of the side load, and the rivets will just hold the two together. Plus, it'll look a lot more "professional" than a few zip ties.
BEN |
|
#2
18-07-2006, 22:50
|
|||
|
|||
|
Re: Timing Belt Clamp
Thanks very much for the ideas an input guys. Sincerely appreciated.
I finally tracked down where to get some (reasonably) today. One of my timing pulley contacts pointed me to one of them, I found the other. FYI< here they are: Still high but I ordered some: www.polytech.com $31.82 45x42mm then of course I found the best place: www.brecoflex.com 50x120mm $22.80 They have larger sizes but those weren't in stock. I can cut out the widths I need from these and probably get 4 or more out of each one. Phew. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Timing Belt and Pulley | Joe_Widen | Technical Discussion | 4 | 16-01-2006 13:41 |
| Specification for timing belt pulley on large CIM? | Larry Barello | Motors | 10 | 15-01-2006 12:21 |
| what is or isn't a timing belt? | archiver | 2001 | 6 | 23-06-2002 23:26 |
| two sided timing belt | archiver | 2001 | 3 | 23-06-2002 22:34 |
| Timing Belt Recommendations? | Eric Reed | Technical Discussion | 1 | 10-01-2002 00:25 |
Hybrid Mode
