|
|
|
 Before anyone accuses FIRST of being in the pocket of the sponsoring corporations, they might spend a minute and a half to actually apply some of that critical analytical ability that we are supposed to be demonstrating as educated engineers. - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
18-07-2006, 09:00
|
||||
|
||||
|
Re: Timing Belt Clamp
Could you just overlap the two open ends of the belt, and then pop rivet it together? The teeth in the belt will take most of the side load, and the rivets will just hold the two together. Plus, it'll look a lot more "professional" than a few zip ties.
BEN |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Timing Belt and Pulley | Joe_Widen | Technical Discussion | 4 | 16-01-2006 13:41 |
| Specification for timing belt pulley on large CIM? | Larry Barello | Motors | 10 | 15-01-2006 12:21 |
| what is or isn't a timing belt? | archiver | 2001 | 6 | 23-06-2002 23:26 |
| two sided timing belt | archiver | 2001 | 3 | 23-06-2002 22:34 |
| Timing Belt Recommendations? | Eric Reed | Technical Discussion | 1 | 10-01-2002 00:25 |
Threaded Mode