|
|
|
 it's not because the kids look up to him that [Dave] gets picked on, it's really because it's just so much fun. - MissInformation [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| it's not because the kids look up to him that [Dave] gets picked on, it's really because it's just so much fun. - MissInformation [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Need Help Making Part from Spec
I've been having some major issues generating an Inventor part based on the attached drawing (PDF).
As the filename says, the drawing is the profile of a dome, so the part has to end up as a 3d dome. I try my best to follow the dimensions as specified, but when I use the Revolve tool on the half-drawing I make, it always leaves a "seam". This is the first part design I've run into in the past two years that I haven't been able to model, so this is driving me crazy. I would really, really appreciate it if someone could make the part and then attach it to this thread or email it to me (maxcutler@gmail.com). |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| i need specs for motors and pumps in the kit from last years competition plz help | SCYTE16 | Motors | 3 | 18-11-2004 22:54 |
| I need help w/ making an Invitational | Matt Attallah | General Forum | 6 | 14-05-2002 19:48 |
| Need Help, from Mentors for Research | Steve Shade | General Forum | 1 | 25-02-2002 15:49 |
| Need Help, from high school students for research | Steve Shade | General Forum | 0 | 24-02-2002 22:18 |
| I need Help from you all. | nick reynolds | Chit-Chat | 18 | 02-11-2001 23:39 |
Threaded Mode