|
|
|
 As Grandma used to say, "empirical data is better than no data at all." - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| As Grandma used to say, "empirical data is better than no data at all." - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
11-08-2006, 00:08
|
|||||
|
|||||
|
Re: CIM Voltage and Motor Suggestions
Okay, I've got a sort of lead for you, but it'll probably require some leg work. I ran across this list of battlebots motor specs. two motors in there look like a good idea for you. The Dewalt 24V hammerdrill motor with gearbox, and the NPC 64038, which you'd have to gear up to twice the speed.
It says the dewalt costs $85, but I have no idea what the part number for all the stuff is. EDIT: So I was bored and did the legwork for you. The drill model is DW006K-2. Get an account on www.dewaltservicenet.com and you can gaze confusedly upon the exploded view of the thing. It looks to me like the parts you'll need will run you from $100-$150 per motor. Depending on how much case you want around it. Last edited by Kevin Sevcik : 11-08-2006 at 00:28. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM motor | Wayne Doenges | Motors | 3 | 06-03-2006 21:24 |
| Small and Large CIM Motor Data | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 0 | 23-02-2006 03:26 |
| CIM motor components | natis | Motors | 4 | 13-01-2006 11:04 |
| CIM-MOTOR source | Andrew Schuetze | Motors | 6 | 18-05-2005 11:57 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |
Threaded Mode