|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
|
|||
|
|||
|
Re: CIM Voltage and Motor Suggestions
Hmmm... See the problem is that if we upgraded the voltage we were using with the CIMs, we would have to re engineer our gearboxes with a different gear ratio so that extra speed would translate into more torque. Since we need to redo the gearboxes either way, those Dewalt ones are looking awfully nice
![]() The one problem at this point seems to be attaching the output shaft on those to our wheel, which has a key slot-thing already cut inside. Any ideas? I can get some dimensions for you guys if that would help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM motor | Wayne Doenges | Motors | 3 | 06-03-2006 21:24 |
| Small and Large CIM Motor Data | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 0 | 23-02-2006 03:26 |
| CIM motor components | natis | Motors | 4 | 13-01-2006 11:04 |
| CIM-MOTOR source | Andrew Schuetze | Motors | 6 | 18-05-2005 11:57 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |