|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: CIM Voltage and Motor Suggestions
Very interesting discussion so far...
I would like to add that the output power of a motor is not only a function of input current but also of the available field in the magnet structure. At some point, the magnetic field developed by the electrical structure may exceed the permanent magnets. At this point, no additional speed or power will be available and all excess electrical input is turned to heat. Without some testing at these extremes, we can not determine a point at which this will occur. Please remember that the resistance of the motor windings and brushes are also affected by heat which will change performance. Unfortunately, as nice as this motor is for a two minute match, it is not designed for anything approaching continuos duty, included are heat dissipation, brush life and bearings. |
|
#2
|
|||
|
|||
|
Re: CIM Voltage and Motor Suggestions
'Unfortunately, as nice as this motor is for a two minute match, it is not designed for anything approaching continuos duty, included are heat dissipation, brush life and bearings."
Which motor are you talking about, the CIM or the recommended Dewalt? |
|
#3
|
|||||
|
|||||
|
Re: CIM Voltage and Motor Suggestions
Quote:
|
|
#4
|
|||
|
|||
|
Re: CIM Voltage and Motor Suggestions
Hey Kevin, or other mechanically inclined person,
Could we use one of these (referenced fromt he NBD whitepaper) as a motor mount with the 24V Hammerdrill motors? http://www.chiefdelphi.com/media/img...e988043e_l.jpg |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM motor | Wayne Doenges | Motors | 3 | 06-03-2006 21:24 |
| Small and Large CIM Motor Data | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 0 | 23-02-2006 03:26 |
| CIM motor components | natis | Motors | 4 | 13-01-2006 11:04 |
| CIM-MOTOR source | Andrew Schuetze | Motors | 6 | 18-05-2005 11:57 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |