|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#20
|
|||
|
|||
|
Re: CIM Voltage and Motor Suggestions
sanddrag, I was talking about the 24V hammerdrill motors that Kevin Sevcik was suggesting. We would be buying the Dewalt motor pack, transmission and some other Misc. parts from the DewaltServiceNet. The part we are trying to work out now is a bearing system or something to handle the side loads. Also, we will be doing a shaft drive system, no chains.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM motor | Wayne Doenges | Motors | 3 | 06-03-2006 21:24 |
| Small and Large CIM Motor Data | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 0 | 23-02-2006 03:26 |
| CIM motor components | natis | Motors | 4 | 13-01-2006 11:04 |
| CIM-MOTOR source | Andrew Schuetze | Motors | 6 | 18-05-2005 11:57 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |