|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#26
|
|||||
|
|||||
|
Re: CIM Voltage and Motor Suggestions
Here's a link to some on McMaster Carr
Drill shaft goes in one side, wheel shaft goes in the other. As you can see, the coupling istelf is only held together if it's pushed from both sides. If you try to bend it or anything it'll just fall apart. So. You mount the drill with that clamp on one side, and then you'll need two bearings supporting the wheel's shaft on the other side. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM motor | Wayne Doenges | Motors | 3 | 06-03-2006 21:24 |
| Small and Large CIM Motor Data | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 0 | 23-02-2006 03:26 |
| CIM motor components | natis | Motors | 4 | 13-01-2006 11:04 |
| CIM-MOTOR source | Andrew Schuetze | Motors | 6 | 18-05-2005 11:57 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |