|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#28
|
|||||
|
|||||
|
Re: CIM Voltage and Motor Suggestions
That and you can use it to more easily couple your direct drive shaft. You can thread one half the coupling and screw it on to the drill, and then use the left hand screw to hold it on. The spider means you can still easily couple it to the other half of the coupling and your wheel shaft.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM motor | Wayne Doenges | Motors | 3 | 06-03-2006 21:24 |
| Small and Large CIM Motor Data | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 0 | 23-02-2006 03:26 |
| CIM motor components | natis | Motors | 4 | 13-01-2006 11:04 |
| CIM-MOTOR source | Andrew Schuetze | Motors | 6 | 18-05-2005 11:57 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |