|
|
|
 People in FIRST ARE lucky, because they are living a very creative adventure which just doesn't let up, and that is okay. Who wants to sit there watching TV and being a spectator anyway. - DougHogg [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#30
24-08-2006, 22:13
|
||||
|
||||
|
Re: Hex Broach Options?
I've been searching around some more for less expensive hex broaches and so far the least expensive I have found are the "Value" hex broaches at J&L:
http://catalogs.shoplocal.com/jlindu...genum ber=418 (see bottom of the page) Has anyone used these? They are significantly less expensive than Dumont anywhere but I am wondering about the quality. I am no stranger to cheap import tools and believe they have there place but I am wondering if these are just a waste of money or a good deal. I haven't had good luck with cheap import taps and dies but have found some of the import drill bits, end mills and collets to be of decent quality for my needs. Does anyone have any guidance on "value" broaches? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hex Couplers | Chris 481 | Technical Discussion | 9 | 03-04-2006 20:49 |
| Standard keyway broach in a metric bushing | sanddrag | Technical Discussion | 2 | 18-02-2006 01:17 |
| hex file garbage? | sciguy125 | Programming | 2 | 04-07-2005 23:04 |
| HEX CRAWLER... | Arefin Bari | Chit-Chat | 3 | 01-05-2004 00:12 |
| Options! | Brandon Martus | Announcements | 0 | 15-04-2002 13:08 |
Threaded Mode