|
|
|
 Don't worry so much about the wording of the rules but the intent of the rules. - Greg Needel [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't worry so much about the wording of the rules but the intent of the rules. - Greg Needel [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Autonomous enable/disable
I'm new to the VEX system. I've searched through the forums but I haven't found what I'm looking for. I'm programming the VEX kit using MPLAB. I'm trying to build a personal project using a VEX kit. I'd like the robot operate autonomously unless the RC is turned on. When it detects a good signal from the RC I'd like it to come out of autonomous mode so it can be controlled by the RC.
Is there any easy way to do this? I know that "txdata.user_cmd = 0x02;" enables autonomous mode and disables the RC. I've noticed that VEX has a light to indicate when it has a good signal from the RC. Does anyone know how to detect a good RC signal in software? Thanks for the help. Andy 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bypass Disable Switch | jakep | Control System | 36 | 19-08-2006 12:46 |
| Question about human disable | Collmandoman | Programming | 6 | 10-03-2005 23:30 |
| enable interrupt | Dean | Programming | 2 | 13-02-2005 07:37 |
Threaded Mode