[OCCRA]: Problem with the compressor, pressure switch, or Bosch relay.

[Josh Murphy]

The wire is connected to the fuse block. The blue goes to the ground block, green plugs into the red wire off of the compressor, black goes into black off of the compressor, and the wires off of the accumalator tank run into the white wire either one works and the other one goes to the positive fuse box. Did you check the pressure gauge so that it is set at 60psi and that it is closed? if it is set there then you may have routed the tubing wrong and it is circulating through the system and it is not building up the pressure, I did that my first time this year and realized it and fixed it so check where you have routed the tubing. I read the pnuematics section in the how to section of the rules book and figured it out in about an hour so try that. good luck and if there is any problem PM me with any questions.

[BrittanyV]

I've hooked up all the wires correctly- that much I'm pretty sure about. I'm not positive the tubing is hooked up correctly, but as far as I can tell, it is. Just to make sure, here's what we have hooked up to what:

The compressor goes to the one way valve which goes to a Y splitter. One end of the split goes to the accumulator tank and the other end goes to the pressure gauge, (which is set at 60 psi) pressure relief valve (or whatever that's called) and the valves and pistons. The pressure switch is screwed into the other end of the accumulator tank.

After reading the manual, that's what I think is correct. If I'm wrong, please tell me!

Thanks,
Brittany

[BrittanyV]

OK, never mind. We figured it out. The pressure switch's screw needed to be turned. We had it the way the manual wanted, but that wasn't working. Thanks a lot though.

Brittany