[OCCRA]: Problem with the compressor, pressure switch, or Bosch relay.

[BrittanyV]

I've hooked up all the wires correctly- that much I'm pretty sure about. I'm not positive the tubing is hooked up correctly, but as far as I can tell, it is. Just to make sure, here's what we have hooked up to what:

The compressor goes to the one way valve which goes to a Y splitter. One end of the split goes to the accumulator tank and the other end goes to the pressure gauge, (which is set at 60 psi) pressure relief valve (or whatever that's called) and the valves and pistons. The pressure switch is screwed into the other end of the accumulator tank.

After reading the manual, that's what I think is correct. If I'm wrong, please tell me!

Thanks,
Brittany

[BrittanyV]

OK, never mind. We figured it out. The pressure switch's screw needed to be turned. We had it the way the manual wanted, but that wasn't working. Thanks a lot though.

Brittany