|
|
|
 Don't get mad, learn, and get even. - Eric O [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't get mad, learn, and get even. - Eric O [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Vex SquareBot- movement programming problem
what is happening is that you are probably going below 0. when that happens it loops back to 255.
just put in an if statement to catch that before it changes speed. the same problem could cause it to go 255 to 0. so put in a if statement to catch that also 
|
|
#2
05-11-2006, 17:19
|
||||
|
||||
|
Re: Vex SquareBot- movement programming problem
Yep, your right! I found this out about an hour after I posted for help. I still don't understand why the value went below 0 though?
Thanks for your help, Nathan
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help needed with coding simultaneous movement (EasyC/VEX) | bodaciousllama | Programming | 7 | 14-08-2006 17:35 |
| pic: Virtual Squarebot | petek | Extra Discussion | 22 | 09-05-2006 16:01 |
| C programming problem... | wasabi824 | Programming | 5 | 08-02-2004 01:04 |
| multi-bank programming problem | GregC | Programming | 3 | 14-02-2003 16:13 |
| programming problem | gthakore | Programming | 16 | 20-04-2002 12:21 |
Hybrid Mode
