|
|
|
 When I encounter Dave at competitions and meetings, I find him to be kind, helpful, almost too nice. When I read his hints, I find him to be EVIL! - Ken Loyd [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#1
|
||||
|
||||
|
Milling a Rubik's Cube? [pic intensive]
My plastic speedcube is nearing the end of its life span (I'm an avg. 35 second cuber w/ partial Fridrich method. it gets lots of wear and tear) and I was considering the possibility of CNCing a more durable cube...so I sat down last night with calipers and a disassembled cube and CADed this up.
Please take a look and tell me if you see any obvious problems. (besides the fact that it will take forever to fabricate and its a crazy idea) The parts with the nice filleted edges are just for visualization, I have versions of all the parts with normal edges which are the ones that I'll actually be using as a template. (Haven't CADed center caps yet)     
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Finally, our new milling machine | Mark McLeod | Extra Discussion | 11 | 23-09-2006 18:30 |
| Rubik's Cube Solving Robot | Alexa Stott | Chit-Chat | 6 | 01-07-2006 13:03 |
| pic: Beautiful Milling Machines | Petey | Robot Showcase | 4 | 13-02-2005 00:52 |
| How an Engineer solves a Rubik's Cube | Hendrix | Math and Science | 21 | 03-06-2004 22:58 |
| LEGOs and the rubik's cube | NoRemorse | General Forum | 5 | 03-05-2004 19:32 |
Threaded Mode