Cannot Program RC

theycallhimtom · #1 28-11-2006, 19:25

There is a difference between programming on the 2005 and 2006 RCs. When you compile the code there are some changes (which I forgot) that you need to do to switch between the do. I'm guessing the master code is setup for 2006 not 2005 so that would be your problem. Also you might want to look into your version of IFI loader.

bear24rw · #2 28-11-2006, 20:21

Make sure you are re-compiling the 06 code with the libraries for the 05 processor.. or just use the 05 default code..

kokodabear · #3 29-11-2006, 17:29

Quote:

Make sure you are re-compiling the 06 code with the libraries for the 05 processor.. or just use the 05 default code..

I'll try that... once I'm able to re-program the thing.

Quote:

if programming from another computer doesn't work, try removing it totally from the bot and try again, if not working at this point, id say call or contact IFI it sounds like it may need their love.

What effect would removing it from the bot do? I would think that turning off the power would have the same effect.

I think I'm gunna call IFI, but thanks for the help

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gearing That Cannot Overcome Static Friction	Madison	Technical Discussion	15	03-08-2006 10:23
help: cannot get the picture in the labVIEW program .. (was: need help!! quickly!)	liad	LabView and Data Acquisition	8	18-01-2006 12:20
Cannot access "double" values	chantilly_team	Programming	14	06-02-2005 13:39
Cannot place constrain in Inventor	Paul Marshall	Inventor	9	05-02-2004 05:56
2 Hours Sleep and I cannot bear to see another nut or bolt..	archiver	2001	2	24-06-2002 00:54