|
|
|
 FIRST is an addiction but at least it is one of the healthiest addictions you can have (if you wear your safety goggles!). - Pavan Dave [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is an addiction but at least it is one of the healthiest addictions you can have (if you wear your safety goggles!). - Pavan Dave [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
09-12-2006, 19:46
|
||||
|
||||
|
Re: interference between wires and connectors
Sorry, I misunderstood that. I only recently started in Inventor and haven't used that feature yet. Is it possible to extrude a small stand-off off of the wire and connect that to the blue connector? Or is that what you meant by "I add four or five points directly above the pin"? Good luck!
EDIT: also is there an "adaptable" option for Cable & Harness, like in other features? If there is, try turning it on and constraining to the blue connector. Last edited by Rob2713g : 09-12-2006 at 19:49. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lines and wires | Andrew Blair | 3D Animation and Competition | 1 | 24-05-2005 21:49 |
| update 8 clarification, drill motor and blue wires | pryoplasm | Rules/Strategy | 23 | 13-02-2004 07:26 |
| Slip connectors (custom electrical connectors) | Damian Manda | Electrical | 2 | 08-02-2003 17:53 |
| Sprockets and Crimp connectors | archiver | 2000 | 1 | 24-06-2002 00:26 |
| RJ-45 connectors, DB25 connectors and the like: legal or no? | Andrew Wyatt | Technical Discussion | 6 | 04-01-2002 22:53 |
Threaded Mode