AndyMark Performance Wheels

[Lil' Lavery]

I saw these (and a number of other products) at Ramp Riot, but these were what I was the most interested in. I'm wondering when more varieties (different diameter and tread sizes) will show up!

[Andy Baker]

Originally Posted by Lil' Lavery

I saw these (and a number of other products) at Ramp Riot, but these were what I was the most interested in. I'm wondering when more varieties (different diameter and tread sizes) will show up!

Thanks for all of the input everyone.

We will decide this coming week if there will be variations. Here are the options we are considering:

8" Performance Wheel w/ 1/2" hex hole
6" Performance Wheel w/ 1.1245" bore for 1/2" id bearings (one on each side)
8" Performance Wheel w/ 1.1245" bore for 1/2" id bearings (one on each side)

These would be a MAYBE at this point. Providing an appropriate amount of intentory on all of these parts is our biggest challenge.

Andy B.

[Billfred]

[joke]I'd pick whatever Dave's picking, in the hopes that he's figured out how to turn one into a boat propeller.[/joke]

Seriously, though if I were presented with those four options in a game similar to recent years, where we haven't had to climb over a six-inch wall or anything, I'd pick the 6" with a bore for bearings. (That said, I'm being ridiculously cost-conscious as I plot and scheme this year; $59 each inclines me towards mixing them with Skyways as insurance in case my driver pulls a 1902 and flies off the ramp.)

[sanddrag]

I'm thinking a 1/2" round bore would be useful. Some teams like to run 1/2" keyed shaft. You can always go bigger, but not easiy go smaller.

[Greg Needel]

Originally Posted by Andy Baker

Thanks for all of the input everyone.

We will decide this coming week if there will be variations. Here are the options we are considering:

8" Performance Wheel w/ 1/2" hex hole
6" Performance Wheel w/ 1.1245" bore for 1/2" id bearings (one on each side)
8" Performance Wheel w/ 1.1245" bore for 1/2" id bearings (one on each side)

These would be a MAYBE at this point. Providing an appropriate amount of intentory on all of these parts is our biggest challenge.

Andy B.

Also just for people FYI you can get 3/8 bearings that have an od of 1.125 so these would be capiable of use with the kit frame.

[Kautz]

I like the 8" Performance Wheel w/ 1/2" hex hole.

We could bore it to 5/8" and key it.

We would run 2 - 8" Trick Wheel (aluminum body) and 2 - 8" Performance Wheel

Hoping for the 8" Performance Wheel w/ 1/2" hex hole.

Thanks for all the good Products Andy and Mark

[Stephen Kowski]

Originally Posted by Lil' Lavery

I'm wondering when more varieties (different diameter and tread sizes) will show up!

Hopefully 4" D X 2" W

[Kyle Love]

When I first saw these wheels in Nov. I was amazed at the extreme light weight of them. They also have a really big "coolfactor".