|
|
|
 Solutions are more likely to be implemented if you provide the solution along with the concern! - Jessica Boucher [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Solutions are more likely to be implemented if you provide the solution along with the concern! - Jessica Boucher [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
29-12-2006, 21:04
|
|||||
|
|||||
|
Re: A source for double strand sprokets..
For three years now my team has used two single sprockets on one shaft with no problems and it was much easier than welding two together as you suggested. Either put the two the hubs face to face, or put a spacer inbetween.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best source for a potentiometer? | railerobotics | Electrical | 20 | 28-11-2007 22:24 |
| Source for Hubs | Tom Saxton | Kit & Additional Hardware | 5 | 12-01-2006 15:48 |
| [OCCRA]: 40t sprokets | troy_573 | OCCRA | 1 | 26-09-2005 00:23 |
| Titanium chain & sprokets | rubicondsrv | Kit & Additional Hardware | 16 | 27-01-2005 13:00 |
| Source for CH Flightsticks | CaptainPlaid | Technical Discussion | 3 | 25-03-2002 12:51 |
Threaded Mode