|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
|
|||||
|
|||||
|
Re: Threaded rod through ball bearings
that's a good point...although from the drawing, it's kind of difficult to figure out just what all the parts are, and how everything is supposed to be held together.
also it's not very difficult to use a die to put threads on the end of a round steel rod, rather than using threaded rod. One could even buy a long bolt, which has threads only on the last inch, cut the head off, and thread the cut off end with a die. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rod-Less Cylider??? | sgsdragons | Pneumatics | 4 | 24-01-2005 19:55 |
| threaded rod | Mercutio | OCCRA | 3 | 28-09-2003 20:45 |
| Drills: The ball bearings are gone? | BobbyG | Motors | 0 | 21-01-2003 23:57 |
| threaded rod fasteners... | archiver | 2001 | 1 | 24-06-2002 00:08 |
| threaded rod? | RobDeCotiis | Kit & Additional Hardware | 4 | 18-02-2002 12:21 |