|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#29
|
||||
|
||||
|
Re: Threaded rod through ball bearings
Keyed shaft material is readily available. You may need to turn and thread the ends, or use shaft collars to accomplish what you want. We don't have machining capabilities, so we use keyed shaft material and collars. We do tend to use a live axle supported at both ends, but once used a cantilevered design without problems, though frame flex had to be prevented.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rod-Less Cylider??? | sgsdragons | Pneumatics | 4 | 24-01-2005 19:55 |
| threaded rod | Mercutio | OCCRA | 3 | 28-09-2003 20:45 |
| Drills: The ball bearings are gone? | BobbyG | Motors | 0 | 21-01-2003 23:57 |
| threaded rod fasteners... | archiver | 2001 | 1 | 24-06-2002 00:08 |
| threaded rod? | RobDeCotiis | Kit & Additional Hardware | 4 | 18-02-2002 12:21 |