|
|
|
 Good Luck all - this one will hurt your brain, but it's all in a good way. - meaubry [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Good Luck all - this one will hurt your brain, but it's all in a good way. - meaubry [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Urgent problem, probably with Inventor 11 install.
Over our winter break, the IT guys at our school came in to install Inventor 11 to the computers here. Inventor 10 worked fine before we left, and we were all looking forward to our upgraded design accelerators among other things. However, much to my dismay, I came in to the room for my first period class, hoping to use Inventor 11, when I found that 10 was still installed. I figured that the IT guys just didn't come in to fix it, but now whenever I try to open 10, it comes up with this message.
Does anyone know what the problem is? EDIT: Sorry for the link to the image, but I didn't want to post a huge image here and stretch the page all over the place. EDIT 2: Looks like the problem was fixed. Thanks for helping. Last edited by Eric Scheuing : 03-01-2007 at 07:43. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| urgent projector problem | sirbleedsalot | IT / Communications | 9 | 10-04-2005 02:54 |
| Urgent!!! Problem concerning Backup battery and autonomous. | Code\\Pilot | Programming | 3 | 26-02-2004 16:44 |
| HELP! Problem with General Dimension in Inventor 5. | sanddrag | Inventor | 12 | 21-09-2003 21:46 |
Threaded Mode