Drawing sprockets in Inventor

[Dan Zollman]

Originally Posted by Biff

This thread should help
http://www.chiefdelphi.com/forums/sh...draw+sprockets

That thread is about alternatives to the Design Accelerator, which isn't very accurate...if you just need this for visual modeling purposes (i.e. NOT when you're going to use the CAD files for fabrication or machining), I think Design Accelerator is much easier than creating the teeth yourself.

To access the Design Accelerator, while you're in the assembly environment, go to the pop-up menu on the panel bar at the left and choose Design Accelerator.

Again, if you need precision, go with that thread.