|
|
|
 Why subject your robot to a potential sensor failure when you can train a monkey (or a student, if monkeys are lacking) to put the tube at the right height every time? - JVN [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Solidworks: Using configurations within assemblies
Hi everyone,
I'm currently drawing up some stuff in solidworks, and I have a part where I have several different configurations. The assembly requires the use of several of these configurations from the same part. I can't seem to find the way to switch what configuration the part uses within the assembly. Anyone know how to do this? Thank you, Dave Team 706 
|
|
#2
10-01-2007, 16:50
|
|||||
|
|||||
|
Re: Solidworks: Using configurations within assemblies
You ought to be able to set the configuration for individual iterations of a single part by right-clicking on the part in the model tree and selecting "Component Properties" near the bottom of the menu that appears.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| possible ramp/lift configurations | zander_108 | Technical Discussion | 24 | 14-01-2007 21:22 |
| constraints in assemblies | Adama | Inventor | 7 | 04-12-2006 16:20 |
| Putting assemblies into other assemblies | Crewmmbr21 | Inventor | 3 | 10-02-2005 16:15 |
| Rank within Divisions | archiver | 2001 | 11 | 24-06-2002 03:06 |
| Inventor Assemblies? | Jon Lawton | Inventor | 11 | 27-01-2002 21:31 |
Linear Mode
