Spring pulling before match or while in match??

Bomberofdoom · #1 10-01-2007, 08:16

Hi, Bomber from team #2230.
We'd like to know, if we have a spring system in the robot, when are we supposed to pull it back? In the match or before the match?

BillP · #2 10-01-2007, 08:25

You can "store" the energy in your spring before the start of the match. Just be careful that the holding mechanism is VERY secure or you will not pass the safety inspection.

ewankoff · #3 10-01-2007, 08:28

Well it largely depends on your system. If you need the spring in a pulled postion to start just be careful because stored energy devices, like spring, can be dangerous when pulled. If you need it contracted to start the match you neednt worry as much. To answer your question there is no mandatory postions springs need to be in to start a match.

Al Skierkiewicz · #4 11-01-2007, 08:03

Bomber,
Stored energy devices do attract the eye of inspectors. Make sure your springs are safely incorporated into your design.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: 1072 before the match	Billfred	Extra Discussion	1	06-01-2007 22:30
Pump operation before match	Jeff Waegelin	Pneumatics	19	29-04-2003 09:42
Match Data	Jack	Scouting	0	08-03-2003 16:49
Match List	Jack	OCCRA	11	03-01-2003 12:33
Pre-Match/Post- Match Pit Routine	Mark_lyons	General Forum	14	31-03-2002 15:19