|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Pillow Block Bearings
Where do you guys get your pillow block bearings?
|
|
#2
|
|||||
|
|||||
|
Re: Pillow Block Bearings
Depending on your use igus might be good for things. Their a lot lighter but are weaker. I dont recomend you use them for drive but places away from direct contact are were these pieces shine.
|
|
#3
|
||||
|
||||
|
Re: Pillow Block Bearings
How about pillow block bearings for main drive components? I'd like cast iron, sealed (no zerks), bearings already put in that accepts 1/2" keyed shaft.
|
|
#4
|
||||
|
||||
|
Re: Pillow Block Bearings
If you are using the banebots gearboxes (the ones that came in the kit of parts), they sell 1/2" bearings. http://www.banebots.com/pc/FIRST/PB-S5002-BB
|
|
#5
|
||||||
|
||||||
|
Re: Pillow Block Bearings
Quote:
If your sprocket is going to be near the bearings, you can probably get away without supporting the Banebot 56mm transmission gearbox but why risk it? The bearing block is $12.50. Use it. You'll sleep better at nights. Joe J. |
|
#6
|
||||
|
||||
|
Re: Pillow Block Bearings
I agree, the pillow block bearings have been included in the past. Oh well.
|
|
#7
|
|||
|
|||
|
Re: Pillow Block Bearings
Pillow block bearings may also be purchased from W. W. Grainger, McMaster Carr, or Stock Drive Products. Check them out on the web. You may have a Grainger Dealer close by.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pillow Block from KOP 2004 | Don Wright | Technical Discussion | 2 | 23-01-2005 17:21 |
| Stinger Fuse Block and Power Distribution Block | Don Wright | Electrical | 2 | 30-03-2004 10:45 |
| Anyone knowwhere to buy maxi block distribution block? | BrianB | Kit & Additional Hardware | 0 | 23-01-2003 12:46 |
| pillow blocks | Jacqui Sutton | Kit & Additional Hardware | 1 | 11-01-2003 10:43 |
| Pillow block | Greg Needel | Technical Discussion | 4 | 01-02-2002 15:18 |