pwms - Chief Delphi

12-01-2007, 04:38

fauxnominal fauxnominal is offline

Registered User

no team

Join Date: Jan 2007

Location: n/a

Posts: 7

fauxnominal is an unknown quantity at this point

Re: pwms

i think what i am confused about the most is how does all the wiring work?
i think code wise i am fine, but when it comes time to test the code, i'm going to have a lot of problems. where do i connect what to make interrupts work beyond the software abstraction?

thanks for all the responses thus far. they are much appreciated.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Good-looking PWMs: is it possible?	Chriszuma	Electrical	2	10-02-2006 00:25
PWMs Active in Programming Mode?	ldeffenb	Control System	4	14-01-2006 07:35
pwms for relays	reilly	Motors	3	18-02-2005 15:02
pwms 13 and 15 in autonomous mode	Chris Bright	Programming	1	24-02-2004 22:25
Mapping Buttons to PWMs	actorindp	Programming	9	10-02-2004 11:11

All times are GMT -5. The time now is 20:52.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.