|
|
|
 Imagine your crate going over Niagara Falls => pack it accordingly (esp if you are attending the Toronto Regional :^) - KenWittlief [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Imagine your crate going over Niagara Falls => pack it accordingly (esp if you are attending the Toronto Regional :^) - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
program camera
I used the kevin.com site to download the frc camera stuff. I used the workbook provided and I'm trying to program the camera. Right now I have power connected from analog output from the controller. I tried using a pwm but it never receives a problem. I tried using a multimeter to measure the voltage on the pwms but I don't receive any kind of power. So I used the 5v that should work. Also I have the serial port connected to the computer. I switch it on, everything is good, there is a red and green light on. I press the program button but it never changes to orange. Plz help quick. thanks.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EasyC Program For Camera? | G1279 | Programming | 1 | 08-01-2007 19:00 |
| Gryo, Camera, Accelorometer, Ultrasonic, and Gear Tooth Sensors in one program | EHaskins | Programming | 8 | 22-05-2006 12:08 |
| Using Easy C to program the camera. | Tazlikesrobots | Programming | 5 | 19-02-2006 21:33 |
| Camera Help (New to Camera Programming) | Idaman323 | Programming | 6 | 14-01-2006 03:56 |
| Trying to import Camera code into program without. | Kingofl337 | Programming | 1 | 18-02-2005 00:43 |
Threaded Mode