|
|
|
 Yeah those design flaws kill you in the end. You especially hate finding out about them in competition. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yeah those design flaws kill you in the end. You especially hate finding out about them in competition. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
gear question
How do I find the Center distances if I want to mate a 20Tooth Gear, 16 DP, 14.5 Pressure Angle, with a Pitch Diameter of 1.25in and Outer of 1.375in with a 60 Tooth Gear 16 DP, 14.5 Pressure Angle, Pitch Diamter 3.75in and a outer diameter of 3.875in?
Thanks for anyone who can help me out. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quick question regarding the gear tooth sensor... | Brad Voracek | Electrical | 3 | 12-01-2007 01:07 |
| Question About Gear Boxes | CE Mexican | Motors | 5 | 19-12-2006 15:14 |
| Gear Tooth Sensor Question | (InsrtNameHere) | Electrical | 2 | 20-01-2006 02:19 |
| Gear reduction question | dmellich | Motors | 6 | 25-01-2003 08:54 |
| motor high gear/low gear switch... | archiver | 2001 | 6 | 23-06-2002 23:50 |
Threaded Mode