|
|
|
"If all else fails, use a bigger hammer" - Steve Florence - Logan Byers [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
|
"If all else fails, use a bigger hammer" - Steve Florence - Logan Byers [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
13-01-2007, 20:13
|
||||
|
||||
|
Re: EasyC OI Inputs?
Worked fine for me today.
Although I started off trying to use pwm14 and pwm15 for motor outputs, then found that only pwm1-12 are supported. Are you having a conflict with int (signed) and unsigned char - whether in your variables to hold raw joystick values, or the printf? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VEX inputs | Andrew Blair | FIRST Tech Challenge | 22 | 31-05-2006 18:17 |
| Analog Inputs | bush | Programming | 5 | 13-03-2006 17:49 |
| Kickoff easyC workshop integrated into EasyC help file | Dan Larochelle | Programming | 0 | 11-01-2006 06:12 |
| PWM inputs? | ghansel | Control System | 7 | 14-09-2005 17:57 |
| Joystick Inputs | Jatheon4316 | Programming | 12 | 06-02-2005 17:25 |
Threaded Mode