|
|
|
 It's what this is all about. Making dreams happen. - Astronouth7303 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It's what this is all about. Making dreams happen. - Astronouth7303 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
14-01-2007, 00:46
|
|||
|
|||
|
Re: Crab drive without a pot
I have a question about using pots on crab drives.
It seems to me like you could have a 359 degree rotation using a pot, but then to go from, say, rightish forward to leftish forward wouldnt you need to rotate the wheel all the way around the long way? Assuming 0 on the pot is straight ahead. Are there pots that give you a range of values up to one turn and if you turn past that they would reset? We were considering using encoders on these shafts... but I'm not the best programmer in the world  Any advice is greatly appreciated. Thank you, Dave |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Crab Drive | Joe_Widen | Extra Discussion | 3 | 23-04-2006 15:49 |
| Crab Drive | Joe_Widen | Technical Discussion | 9 | 21-04-2006 21:50 |
| Crab drive question | Tazlikesrobots | Technical Discussion | 13 | 31-07-2005 20:51 |
| EduRobot Crab Drive | OneAngryDaisy | Robotics Education and Curriculum | 8 | 03-10-2003 10:06 |
| Crab Drive | Collin Fultz | Technical Discussion | 3 | 04-09-2002 16:35 |
Threaded Mode