Attempting to Cut BaneBot 56mm Shaft

its kind of a bad idea to implement traction control when you have no traction in the first place. - Uberbots [more]

		Chief Delphi > Technical > Motors
Attempting to Cut BaneBot 56mm Shaft

Thread Tools

Rate Thread

Display Modes

14-01-2007, 17:11

edthegeek

AMHS/Case Western Reserve Universit

AKA: Eduardo Arellano

no team (TKO)

Team Role: Mentor

Join Date: Dec 2005

Rookie Year: 2004

Location: San Jose, California

Posts: 33

Attempting to Cut BaneBot 56mm Shaft

Does anybody know the material of the shaft in the BaneBots 56 mm gearbox? And has anybody tried cutting/truncating it and have any tips. We have a small Smithy mill that we can use, but don't know if this is the best way to cut it.

__________________
"You do realize that most of the substances that you are inhaling right now are considered toxic in the state of California"
-Paolo to me while I am covered in Teflon and soldering.
"Stupid Chinese 6011 Alloy is stronger than we thought."
"Comrade, your sacrifice brings honor to the motherbot."

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BaneBot Transmission Encoder	Daru	Motors	9	27-01-2007 23:17
Banebot 2 motor adapter	Ben Piecuch	Motors	5	17-01-2007 16:06
Banebot Gearbox	chris31	Technical Discussion	45	15-01-2007 17:56
56mm BaneBot Gearbox 15tooth sprockets. Where to buy more?	VEN	Technical Discussion	4	11-01-2007 14:45
Big Shaft to Little Shaft?	Anton Abaya	Technical Discussion	7	21-01-2002 19:27

All times are GMT -5. The time now is 21:53.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.