|
|
|
 ...I'm still waiting for a Chiefdelph-aholics group to form at the local YMCA. - KelliV [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ...I'm still waiting for a Chiefdelph-aholics group to form at the local YMCA. - KelliV [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
14-01-2007, 23:04
|
||||
|
||||
|
Re: PWM 13-16 Replacement Code Beta Test
Hey Kevin? Does your code leave a pause between pulses sent from the CCP module? After looking at your code I did not see anything to indicate this. The reason I ask is because I have noticed that when continuous pulses are sent to a servo using the CCP module, the servo exhibits jitter. I have found that a 2ms delay or greater between pulses will stop this behavior. Have you encountered similar behavior?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vex start up code run PWM outputs without Rx | intellec7 | Programming | 3 | 05-05-2006 23:29 |
| Pwm 11, 12 and CMU code | Chris Bright | Programming | 3 | 01-02-2005 19:34 |
| Victor Replacement | JamesCH95 | Electrical | 4 | 15-12-2004 20:12 |
| Replacement Parts | archiver | 1999 | 0 | 23-06-2002 22:01 |
| replacement gears | joni_m | Technical Discussion | 1 | 22-01-2002 18:01 |
Threaded Mode