|
|
|
 We know that the real goal of FIRST is not for this robot to win, but that we learn something. If i was on robotics to win, it wouldn't be nearly as fun. - Nin_estarSaerah [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Configuring Labview code to easyC
Hi there, after lots of troubleshooting I got to where i should save labview to easyC code and when i did that it did not save it as a .ECC file it saved it as a configuration setting. Therefore when i tried to run it on easyC it wasnt there. If you can help me settle this problem it would be greatly appreciated.
Thank you.... Adam, Programming 
|
|
#2
15-01-2007, 13:24
|
||||
|
||||
|
Re: Configuring Labview code to easyC
Once you load the labview file into easyC it will save those values in the current project.
|
|
#4
15-01-2007, 13:40
|
||||
|
||||
|
Re: Configuring Labview code to easyC
Oh, I get it, can you e-mail me that file to amartin "at" intelitek.com
|
|
#6
16-01-2007, 01:11
|
|||||
|
|||||
|
Re: Configuring Labview code to easyC
When you guys get your issue resolved, do you mind posting your results?
-Danny
|
|
#7
16-01-2007, 09:21
|
||||
|
||||
|
Re: Configuring Labview code to easyC
Labview changed the file to a .ini from a .ecc. So just rename the file labview generates to a .ecc and easyC will load it. We will update easyC in the next build.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| easyC Mechanum Drive Code | Kingofl337 | Programming | 0 | 12-01-2007 23:48 |
| EasyC: Execute code before autonomous | Greg Marra | Programming | 7 | 07-01-2007 21:30 |
| EasyC Default Code | Team 1649 | Programming | 13 | 29-01-2006 11:52 |
| LabView Gear Tooth Sensor Code | SkiRacer | LabView and Data Acquisition | 2 | 17-01-2006 03:53 |
| VS.NET 2003 Configuring | D.Viddy | Programming | 5 | 20-01-2004 21:24 |
Hybrid Mode
