Configuring Labview code to easyC

Just wear your safety glasses. They can be stylish, too! - Eugenia Gabrielov [more]

		Chief Delphi > Technical > National Instruments LabVIEW and Data Acquisition > LabView and Data Acquisition
Configuring Labview code to easyC

Thread Tools

Rate Thread

Display Modes

15-01-2007, 13:17

team877

Registered User

FRC #0877 (Cub Robotics)

Team Role: Programmer

Join Date: Jan 2007

Rookie Year: 2001

Location: North Dakota

Posts: 52

team877 is an unknown quantity at this point

Configuring Labview code to easyC

Hi there, after lots of troubleshooting I got to where i should save labview to easyC code and when i did that it did not save it as a .ECC file it saved it as a configuration setting. Therefore when i tried to run it on easyC it wasnt there. If you can help me settle this problem it would be greatly appreciated.

Thank you....
Adam, Programming

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
easyC Mechanum Drive Code	Kingofl337	Programming	0	12-01-2007 23:48
EasyC: Execute code before autonomous	Greg Marra	Programming	7	07-01-2007 21:30
EasyC Default Code	Team 1649	Programming	13	29-01-2006 11:52
LabView Gear Tooth Sensor Code	SkiRacer	LabView and Data Acquisition	2	17-01-2006 03:53
VS.NET 2003 Configuring	D.Viddy	Programming	5	20-01-2004 21:24

All times are GMT -5. The time now is 00:19.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.