|
|
|
 My wife is in advertising, and uses a scary amount of math. They have to know how to target you and beat down your defenses, so that you buy that hamburger while driving that car while wearing those designer jeans to your favorite store. - Not2B [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#11
15-01-2007, 15:06
|
|||||
|
|||||
|
Re: Custom PWM Cables and R69
Daniel,
The speed controllers do not use the 5 volt wire but do use the signal wire and ground. I am having a brain cloud on the Spikes, but I believe all three wires are in use but the relay outputs are different than the PWM outputs on the RC. The servos use all three. I would prefer to use the standard PWM cable for all three and have standard wiring throughout the robot. Last edited by Al Skierkiewicz : 16-01-2007 at 07:30. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PWM Cables | Alex Cormier | FIRST Tech Challenge | 15 | 13-08-2006 09:48 |
| PWM Cables | zachriggle | Electrical | 3 | 04-02-2006 13:54 |
| Bad Pwm cables | Greg Needel | Electrical | 7 | 18-01-2006 23:13 |
| victors spikes and pwm cables | sburro | Electrical | 3 | 23-02-2005 02:24 |
| The PWM Cables | amateurrobotguy | General Forum | 1 | 22-02-2005 17:42 |
Threaded Mode