|
|
|
 I don't remember ever having "attack of the jumbo ball" in FRC! - Beth Sweet [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't remember ever having "attack of the jumbo ball" in FRC! - Beth Sweet [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
bumper question
according to the manual, we can have segmented bumpers (not the complete length of the robot side). it says the minimum length is 6 inches. however, the rules also say the bumpers can extend into the corner space up to 3.5 inches (only the noodle and cloth parts).
so, can that 3.5 inches count as part of the 6 inch minimum? what i mean is, im trying to get the widest possible space in-between two bumper segments. if the 6 inches has to be within the 28 robot width, then the widest is 28 - 6 - 6 = 16 inches gap. is it possible to increase that gap by moving the bumpers into the corner area (outside the 28x38 envelope)? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about programing the bumper sensors | itsme | Programming | 9 | 10-12-2006 18:03 |
| Bumper rules | robotraj111 | Kit & Additional Hardware | 1 | 19-02-2006 20:36 |
| noodle bumper | munch | General Forum | 2 | 09-02-2006 17:25 |
| bumper customization? | gondorf | General Forum | 20 | 01-02-2006 19:30 |
| Bumper or No? | WebWader125 | Technical Discussion | 19 | 11-01-2006 01:28 |
Threaded Mode