|
|
|
 You have to admit, Regionals are pretty strange places, albiet cool - Otaku [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You have to admit, Regionals are pretty strange places, albiet cool - Otaku [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
15-01-2007, 23:37
|
||||
|
||||
|
Re: Servo Strength
The servos provide 42 oz-in of torque, which is relatively low compared to a high torque servo, but it still may be adequate, just depends on how much you gear it down
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Championship Division Strength | Rob | Championship Event | 26 | 06-04-2006 18:19 |
| Strength difference between aluminum | sdcantrell56 | Technical Discussion | 3 | 21-01-2006 10:07 |
| Servo behavior question / advanced servo/PIC programming question | DanL | Electrical | 12 | 18-10-2005 18:33 |
| Strength of welds on gears | sanddrag | Technical Discussion | 16 | 30-01-2004 17:32 |
| shear strength | Andrew Dahl | Technical Discussion | 1 | 14-02-2002 10:02 |
Threaded Mode