Question Concerning Operator Interface Inputs

[d.courtney]

So, I don't know to much about custom inputs to the OI, and I thought I would ask you guys before I did something terribly wrong. I want to know how (if its even possible) I would have a rotational sensor, encoder, or gyro, be an input for the OI, there were a few ideas I had this for. just wondering if it was possible given our OI or if I was wasting my time.

Thanks
David Courtney

edit: I realize this is in the programming section, not the control/OI section, thats because the question was mainly from a programming standpoint, ie what special programming would be required.