|
|
|
 Why do FIRSTers think we're better? ...because we hold values like honesty, integrity, and intelligence dear... - Redneck [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Why do FIRSTers think we're better? ...because we hold values like honesty, integrity, and intelligence dear... - Redneck [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Question Concerning Operator Interface Inputs
So, I don't know to much about custom inputs to the OI, and I thought I would ask you guys before I did something terribly wrong. I want to know how (if its even possible) I would have a rotational sensor, encoder, or gyro, be an input for the OI, there were a few ideas I had this for. just wondering if it was possible given our OI or if I was wasting my time.
Thanks David Courtney edit: I realize this is in the programming section, not the control/OI section, thats because the question was mainly from a programming standpoint, ie what special programming would be required. Last edited by d.courtney : 16-01-2007 at 00:06. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2005 Operator Interface | mtaman02 | Control System | 0 | 11-01-2007 19:12 |
| operator interface | tml240 | Electrical | 5 | 10-02-2004 17:50 |
| Operator Interface code | RiotingNerd | Programming | 5 | 07-02-2004 21:13 |
| Operator Interface Heads Up | Madison | Robotics Education and Curriculum | 6 | 11-12-2002 06:59 |
| Operator Interface Improvements | Dan | Technical Discussion | 3 | 18-02-2002 19:23 |
Threaded Mode