|
|
|
 Have you been formally diagnosed as a masochist, or are you just a mentor? - GeeTwo [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Have you been formally diagnosed as a masochist, or are you just a mentor? - GeeTwo [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
16-01-2007, 09:03
|
||||
|
||||
|
Re: Victor Brakes
When I tried hooking the SIGNAL pin of a Digital Output directly to the centre pin of the Victor Brake/Coast header (2006 Robot Controller) the red HARDWARE LED comes on (Master Reset), on the Robot Controller.
This can't be good  Shouldn't the Relay Outputs on the Robot Controller be used instead??? I have been unable to find a schematic for the Victor controller showing the Brake/Coast jumper. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Brakes | pakrat | Technical Discussion | 34 | 06-05-2006 11:45 |
| pic: Brakes in action! | falconmaster | Robot Showcase | 4 | 04-02-2006 12:57 |
| Plants in my Victor? | Rickertsen2 | Electrical | 1 | 23-10-2005 20:47 |
| Victor 884's not behaving the same as Victor 883's | programmer1 | Programming | 13 | 10-03-2004 21:51 |
| Victor problems | quickie25 | General Forum | 2 | 18-02-2004 19:51 |
Threaded Mode